ISO-14165-116-FDAM-1-2008.pdf

Please see the administrative notes on page iii RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPORT- ING DOCUMENTATION. IN ADDITION TO THEIR EVALUATION AS BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO- LOGICAL, COMMERCIAL AND USER PURPOSES, DRAFT INTERNATIONAL STANDARDS MAY ON OCCASION HAVE TO BE CONSIDERED IN THE LIGHT OF THEIR POTENTIAL TO BECOME STAN- DARDS TO WHICH REFERENCE MAY BE MADE IN NATIONAL REGULATIONS. Reference number ISO/IEC 14165-116:2005/FDAM 1:2008(E) © ISO/IEC 2008 FINAL DRAFT ISO/IEC JTC 1 Secretariat: ANSI Voting begins on: 2008-10-20 Voting terminates on: 2008-12-20 AMENDMENT ISO/IEC 14165-116:2005 FDAM 1 Information technology Fibre Channel Part 116: 10 Gigabit (10GFC) AMENDMENT 1 Technologies de l'information Canal de fibres Partie 116: 10 gigabits (10GFC) AMENDEMENT 1 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 01/30/2009 00:07:52 MSTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 14165-116:2005/FDAM 1:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. Copyright notice This ISO document is a Draft International Standard and is copyright-protected by ISO. Except as permitted under the applicable laws of the user's country, neither this ISO draft nor any extract from it may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, photocopying, recording or otherwise, without prior written permission being secured. Requests for permission to reproduce should be addressed to either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Reproduction may be subject to royalty payments or a licensing agreement. Violators may be prosecuted. ii © ISO/IEC 2008 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 01/30/2009 00:07:52 MSTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 14165-116:2005/FDAM 1:2008(E) © ISO/IEC 2008 All rights reserved iii In accordance with the provisions of Council Resolution 21/1986, this document is circulated in the English language only. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 01/30/2009 00:07:52 MSTNo reproduction or networking permitted without license from IHS -,-,- FDAM1 to 14165-116 © ISO/IEC - 2 -2008-08 2 FOREWORD Amendment 1 to International Standard ISO/IEC 14165-116:2005 was prepared by subcommittee 25: Interconnec- tion of information technology equipment, of ISO/IEC joint technical committee 1: Information technology. This International Standard has been approved by vote of the member bodies, and the voting results may be obtained from the address given on the second title page. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 01/30/2009 00:07:52 MSTNo reproduction or networking permitted without license from IHS -,-,- 2008-08- 3 -FDAM1 to 14165-116 © ISO/IEC INTRODUCTION to the Amendment 1 This amendment to ISO/IEC 14165-116:2005 (Fibre Channel - 10 Gigabit) corrects the definition of the clock synchronization primitives (Clock Synchronization Word X, Clock Synchronization Word Y, and Clock Synchronization Word Z) to comply with ISO/IEC 14165-252 (Fibre Channel - Framing and Signaling-2). Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 01/30/2009 00:07:52 MSTNo reproduction or networking permitted without license from IHS -,-,- FDAM1 to 14165-116 © ISO/IEC - 4 -2008-08 4 Page 11 Normative references Add the following reference ISO/IEC 14165-252, Fibre Channel - Framing and Signaling (FC-FS-2) ANSI/INCITS 424-2006 Page 12 3.1 Definitions Add the following definitions 3.1.2 Ordered Set A Transmission Word composed of a special character in its first (left-most) position and data characters in its remaining positions. See Add the following reference. 3.1.3 Primitive Signal An Ordered Set designated to have a special meaning (e.g., an Idle or R_RDY). See FC-FS-2. Page 48 Table 22 Primitive signals (standard) Replace last three lines with the following. SYNx SYNx_X Clock Synchronization Word XFC-FS-2K28.5 - D31.3 - CS_X1- CS_X2 10GFCK28.2 - D31.3 - CS_X1- CS_X2 SYNy SYNy_X Clock Synchronization Word YFC-FS-2K28.5 - D31.5 - CS_Y1- CS_Y2 10GFCK28.2 - D31.5 - CS_Y1- CS_Y2 SYNz SYNz_X Clock Synchronization Word ZFC-FS-2K28.5 - D31.6 - CS_Z1 - CS_Z2 10GFCK28.2 - D31.6 - CS_Z1- CS_Z2 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 01/30/2009 00:07:52 MSTNo reproduction or networking permitted without license from IHS -,-,-