SAE-AS-125851-THRU-AS-125875B-2007.pdf
《SAE-AS-125851-THRU-AS-125875B-2007.pdf》由会员分享,可在线阅读,更多相关《SAE-AS-125851-THRU-AS-125875B-2007.pdf(2页珍藏版)》请在三一文库上搜索。
1、 AEROSPACE STANDARD (R) PLUG - PIPE, CADMIUM PLATED, STEEL UNS G87400, COUNTERSUNK HEX AS125851 THRU AS125875 Copyright 2007 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mec
2、hanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org ISSUED 1953-01 REAFFIRM
3、ED 2006-08 REVISED 2007-05 THIRD ANGLE PROJECTION CUSTODIAN: SAE E-25 REV. B FEDERAL SUPPLY CLASS 5307 AS125851 THRU AS125875 SHEET 1 OF 2 REV. B PROCUREMENT SPECIFICATION: NONE SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and e
4、ngineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it
5、may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. RATIONALE UPDATE STANDARD, CHANGE PIPE THREAD TO AS71051, AND ADD CADMIUM WARNING NOTE. SECTION THRU THREAD PROFILE BOTH ENDS 32 F C L CHAMFER Y x 45 APPROX OPPOSITE END OPTIONAL o B SHAPE OF SOCKET BOTTOM O
6、PTIONAL. DRILL POINT PERMISSIBLE. SHALL BE WITHIN DIMENSIONS SHOWN AND FREE FROM CHIPS AND BURRS. THREAD ANPT SPEC AS71051 D FIGURE 1 - PLUG TABLE 1 - PART NUMBERS AND DIMENSIONS PART NUMBER NOMINAL PIPE THREAD B MIN C MIN D L F MAX Y AS125851 AS125852 AS125853 AS125854 AS125855 AS124856 AS125857 AS
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- SAE AS 125851 THRU 125875 2007
![提示](https://www.31doc.com/images/bang_tan.gif)
链接地址:https://www.31doc.com/p-3793123.html